California Instruments 801RP Series User And Programming Manual
Also see for 801RP Series: Training manual
                                                                                     | |
Contents
| 
User and Programming Manual - Rev P California Instruments9. PGUI32 Setup and InstallationThis section covers installation of the PGUI32 from the distribution disk to the user’s PC.Make sure the PC is capable of running Windows with at least 256 Mbyte of memory and 4Mbyte of available hard disk space.9.1. Connecting the AC Source to the PC When Using RS232Connect the AC source to the PC using an RS232C cable.The AC source com port settings are set as follows:Baud rate: 9600 baudData bits: 8Stop bits 1Parity bits: noneHandshake: HardwareThe AC source is configured to accept the above setting.Select the RS232 interface by sliding the interface selection DIP switch on the rear panel tothe RS232 position.9.2. Connecting the AC Source to the PC Using IEEE-488Connect the AC source to the PC using an IEEE-488 interface cable. A NationalInstruments GPIB controller card is required to use the PGUI32 program.Select the IEEE-488 interface by sliding the interface selection DIP-switch on the rear panelto the IEEE-488 position.Set the desired IEEE address using DIP switch position 4 through 0 on the rear panel.9.3. Installing the PGUI32 SoftwareThe PGUI32 software is distributed on CD ROM (CIC496) or can be downloaded from theCalifornia Instruments website. To install the PGUI32, proceed as follows:1. Turn on the PC and boot up in Windows™2. Insert the CD ROM.3. Run the Setup.exe program to launch the CD Browser if it did not auto start. From theCD Browser, select the 801P/1001P/1251P entry in the Low Power category on the left.4. Select the GUI Software tab on the right and select the Windows 32 bit version. Thenclick on the Execute Selection button at the bottom.5. Follow the instructions provided by the setup program to complete the installation.October 2005 RP Series36 |
Related manuals for California Instruments 801RP Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine