Turning Off Envelope ModeAfter printing on envelopes, follow these steps before loading normal paper again:1. Set the paper selection lever (on the right side of the sheet feeder) to the back position.2. Set the green paper thickness lever (inside the printer) to the down position.3. If you enabled the envelope mode, disable it now:Press the ON LINE button to set the printer off-line.Press the envelope button to turn off the envelope light.Press the ON LINE to set the printer back on-line.4. In the Microsoft Windows Printing System Setup dialog box, change the Paper Size setting back toLetter or to the paper size you are using.Specifying Page LengthIn some MS-DOS applications, you may need to specify the page length in lines per page. For letter-sizepaper, the page length is 64 lines, and for legal-size paper, the page length is 82 lines.If you are using an application that does not include a page setup or printer setup procedure, you may beable to use the ESCape sequence to specify your page length. Applications handle ESCape sequencesdifferently, so refer to your application's software manual for instructions on sending commands.The ESCape sequence for page length is ESC C 0 n, where n is the page length in inches. For legal-sizepaper, the ESCape sequence is ESC C 0 14 (27 67 0 14, decimal, or 1B 43 00 0E, hexadecimal).Using the Printer With MS-DOS 2241 of 1 4/15/98 2:16 PM