Basic Printing5The S630 can print on paper ranging fromstandard copier paper (usually 17–28 lb.) tospecialty media paper and envelopes.The paper thickness lever is located inside thefront cover, on the printhead holder. It controlsthe paper feed for the type and weight of themedia on which you are printing.For envelopes (see “To load envelopes:”on page 6), bannersand T-Shirt Transfers.For regular paper and other media with a left position in the table (see“Load Limit and Paper Thickness Lever Position” on page 4).Use the chart on the previous page to ensure that the paper thickness lever is setcorrectly for the type of media you are using.To load paper or other media:1. Make sure the paper thickness lever is setcorrectly for the media used.2. Slide the paper guide completely to the left.3. Fan the edges of the sheets to remove staticcling and avoid paper jams, then tap theedges of the stack against a flat surface sothe stack is aligned.4. Insert the media into the paper rest, withthe print side facing up.5. Slide the paper guide to the edge of the media until it is firmly in place.Some papers, especially specialty media, have specific sides forprinting. The print side is usually the glossier side or the brighterwhite side.When using specialty media, do not touch the print side.You can load up to 100 sheets of plain (17 lb.) paper or 80 sheetsof Canon High Resolution Paper in the paper rest at one time.Never load the paper above the load limit mark.Load limit markPrint side