134REFERENCEMode Blinking warning DescriptionSubject is too dark.Subject is too bright.Picture will be underexposed.Picture will be overexposed.Picture will be underexposed.Picture will be overexposed.The desired depth of fieldcannot be obtained.Subject is too dark.Subject is too bright.RemarksUse flash.Use a neutral density filter.Turn the 〈 〉 dial to aslower shutter speed.Turn the 〈 〉 dial to afaster shutter speed.Turn the 〈 〉 dial to asmaller aperture value.Turn the 〈 〉 dial to alarger aperture value.1) Move farther from thesubject and try again.2) If using a zoom lens, usethe shortest focal length.Use a flash (the result willbe the same as usingProgram AE 〈 〉).Use a neutral density filter.Exposure WarningsThe warnings shown are examples using a lens with a minimum aperture value off/3.5, and a maximum aperture value of f/22. Actual maximum and minimumaperture values will depend on the particular lens you use.AE Lock Effects for Combinations of FocusingPoint Selection and Metering MethodFocusing point selectionMetering methodEvaluative meteringPartial meteringCenter-weighted averagingAuto selection AFAE lock applied to themetered value at the activefocusing point.Manual selection AFAE lock applied to themetered value at theselected focusing point.AE lock applied to the metered value at the center focusingpoint.(when using a mode in the Creative zone)
