Canon FAX-JX300 User Manual

Also see for FAX JX200: Manual Easy Setup instructions User guide User guide Service manual

Contents

30 Receiving FaxesCanceling Receiving1 Press [Stop].Telstra FaxStream™ Duet (Australia only)Telstra offers the FaxStream™ Duet capability. If you subscribe to this service, your line is assignedtwo numbers: one for fax and one for phone. When the fax number is called, the network sends aspecific ringing tone which your fax recognizes and automatically handles as a fax call. If the phonenumber is called, a different ringing tone is sent out from the network so that the call is handled as avoice call. This means that there is no switching delay at the other party’s end.Contact Telstra for connection information. Setting the Fax for Network Switchz When the fax number is called, you will hear a triple-ring* ringing tone.z When the telephone number is called, you will hear a ringing tone other than the triple-ringringing tone. The ringing tone depends on your switchboard.1 Press [Receive Mode/Resolution] to select .See “Setting the Receive Mode” on page 28.}The fax returns to standby mode.* Three short rings (short-short-short) at regular intervals. Operation for Network Switch SystemThe procedures for using the network switch system are almost the same as when using the faxover a normal telephone line. When you receive calls, however, the fax will respond slightlydifferently as described below.When you hear the telephone call ring pattern:Pick up the Handset and talk normally. If you hear a slow beep, it means the call is from a faxmachine trying to send a document. Press [Start/Copy] to receive the document. If you do notpick up the Handset, the fax continues to ring until the other party hangs up. If an answeringmachine is connected**, it takes over the call.** FAX-JX500/JX300 only.When you hear the fax call ring pattern (triple ring):After the fax rings, it receives the document automatically.