| 
45Using TAM Mode (FAX-JX500/JX300 only)Forwarding Telephone MessagesThis feature allows you to automatically forward telephone messages, recorded when the fax is setto , to a registered forwarding number.You can use remote control to access the forwarding number and listen to your telephonemessages. Setting the Forwarding Number1 Press [Menu].2 Use [{] or [}] to select , then press [Start/Copy]. TheLCD displays .3 Use [{] or [}] to select , then press [Start/Copy]. The LCDdisplays .4 Use [{] or [}] to select , then press [Start/Copy]. The LCDdisplays .5 Use [{] or [}] to select , then press [Start/Copy] twice. The LCD displays.6 Use the numeric buttons to enter the forwarding number, then press [Start/Copy].A maximum of 40 digits can be entered.7 Press [Stop].Setting ends and the fax returns to standby mode. Setting the Number of Redial Times1 Follow steps 1 to 4 on page 45.2 Use [{] or [}] to select , then press [Start/Copy]. The LCD displays TEL NUMBER>.3 Use [{] or [}] to select , then press [Start/Copy]. The LCDdisplays .4 Use [{] or [}] to select , then press [Start/Copy] twice. The LCD displays<2TIMES>.5 Use the numeric buttons, or [{] or [}] to enter the number of redial times, thenpress [Start/Copy] twice. The LCD displays <2MIN.>.Notez You must register a forwarding number and set before you can use this feature. Remotecontrol cannot be used to set this feature unless a forwarding number has been registered.z If you set to when a forwarding message has not been recorded, you willhear a tone instead of a forwarding message when telephone messages are forwarded. |
