CHAPTER 3 MECHANICAL SYSTEM3-24 COPYRIGHT © 1998 CANON INC. CANON DADF-A1 REV.0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)I. Stopper Plate Solenoid1. Removing the Stopper PlateSolenoid1) Remove the body cover.2) Remove the two screws [1], and removethe original tray mounting plate [2].[1] [2] [1]Figure 3-3473) Remove the two screws, and disconnectthe connector [4]; then, remove the stopperplate solenoid [5].[3][5] [4]Figure 3-3482. Making Adjustments1) Secure the solenoid [1] in place where thestopper [3] (rubber block) butts against therear edge of the stopper plate [2] when theplunger of the solenoid [1] is at the end ofits stroke.[1][2][3]Figure 3-349J. Positioning the PaperRetaining Plate Solenoid(SL2)1) Prepare test strips.Cut a sheet of A4 or LTR paper (64 g/m 2 )into widths of about 70 mm each.70 mm (approx.)Vertical1/31/31/3Figure 3-350
