Canon JX510P User Manual

Contents

21Before Using Your MachineENGLISHLoading Documents and Paper1 Open the Document Cover (1) and extend thePaper Support (2) to support the paper.2 Squeeze, then slide the Paper Guide to theleft.3 Insert the stack face up into the Rear Tray (1),and align the right edge of the stack with theright side of the Rear Tray. Then slide thePaper Guide (2) snugly against the left edgeof the stack.z Do not load higher than the paper limit mark ( ).z Be careful not to press the Paper Guide stronglyagainst the stack, or the paper will not be fedproperly.4 Gently insert the top of the document face upinto the ADF until you hear a beep, adjust theDocument Guide to the width of thedocument.z To avoid feeding problems, make sure thedocument meets the document requirements (seepage 19).Notez For a multipage document, the pages are fed one by one from the top of the stack.z Wait until all pages of your document have been scanned before starting a new job.z Make sure you follow the procedure to load documents into the ADF. If the document is not loaded intothe ADF correctly, it may not be fed into the fax properly; resulting in a jam, or in pages not being sent.z If you want to send a document with more than 20 (10 legal-size) pages, divide the document intosections and send each section in a separate transmission.z For multipage documents, tap the stack on a flat surface to even the edges before loading.(1)(2)(1)(2)(1)(2)