Preface ixHT1-2205-000-V.1.0 LSL User’s GuideUSERS IN CANADAPRE-INSTALLATION REQUIREMENTS FOR CANONFACSIMILE EQUIPMENTA. LocationSupply a suitable table, cabinet, or desk. See the Appendix for themachine’s dimensions and weight.B. Order Information1. Provide only a single-line to touch-tone or rotary telephone setterminated with a standard 4-pin modular phone plug. (Touch-tone is recommended if available in your area.)2. Order an CA11A modular jack (USOC code), which should beinstalled by the telephone company. If the CA11A jack is notpresent, installation cannot occur.3. Order a normal business line from your telephone company’sbusiness representative. The line should be a regular voice gradeline or equivalent. Use one line per machine.DDD (DIRECT DISTANCE DIAL) LINE-or-IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IFYOU COMMUNICATE OVERSEASCanon recommends an individual line following industry standards [e.g.,the 2500 (touch tone) or 500 (rotary/pulse dial) telephones]. A dedicatedextension off a PBX unit without “Camp On” signals is also permissiblewith your LASER CLASS 2050P. Key telephone systems are notrecommended because they send non-standard signals to individualtelephones for ringing and special codes, which may cause a fax error.C. Power RequirementsThe power outlet should be a three-prong grounded receptacle(Single or Duplex). It should be independent from copiers, heaters,air conditioners or any electric equipment that is thermostaticallycontrolled. The rated value is 120-127 volts and 15 amperes.nl-1100.book Page ix Friday, December 13, 2002 5:07 PM
