3-8MultiPASS C530/C560 Chapter 3: Maintenance & ServiceCenter0 dot⇐Misalignment Direction : "LEFT" Misalignment Direction : "RIGHT"⇒Printout of 1st linePrintout of 2nd linePrintout of 3rd line ⇐⇒⇐1 dot2 dot 1 dot 2 dotd) Correction procedureThe misaligned vertical lines in the middle, shown inFig. 3-6, are described below.(1) Check the correction direction for the 2nd line, and check the dot count. (In the example, a 2-dotcorrection to the right is necessary.)(2) Determine the dot count required for the correction.In SHQ, the dot count is roughly 4.55 times. (E.g., 2 × 4.55 = 9)In HQ, the dot count is roughly 2.86 times. (E.g., 2 × 2.86 = 6)In HS, the dot count is 2 times. (E.g., 2 × 2 = 4)(3) As shown inFig. 3-7, make the correction for all print mode. (The flowchart shows the procedure formaking a 2-dot correction to the right for the all print mode, respectively. The actual display maylook different from the figure.)(4) After making the correction, print out the test pattern. If there is any misalignment, do the correctionagain.Figure 3-5 Correct Test PatternExample: A 2-dot correction on the right is necessaryCenterPrintout of 1st linePrintout of 2nd linePrintout of 3rd lineFigure 3-6 Sample Test Pattern with Vertical MisalignmentAll registration defaults are 0.SHQ2 mode is not used in this model.NOTE
