110 Chapter 11Troubleshooting*1 To resume printing, you can press [OK] on the machine instead of selecting Continue.Waste tank (ink absorber) full This error message indicates that the waste ink absorber is nearly full.The machine has a built-in waste ink absorber to hold the ink used duringFINE Cartridge cleaning, for example.You can continue printing by selecting Continue*1 on the display on yourcamera.However, because printing is disabled once the waste ink absorberbecomes completely full and until the waste ink absorber is replaced, youare recommended to contact a Canon service representative as soon aspossible.No ink z Prepare a new FINE Cartridge.Select Continue*1 in the display on your camera to resume printing.z Replace the FINE Cartridge and close the Scanning Unit.If printing is in progress and you want to continue printing, press [OK]with the FINE Cartridge installed.Then printing can continue under the ink out condition by selectingContinue*1 on the display on your camera.Replace the empty FINE Cartridge immediately after this printout. Themachine may be damaged if printing is continued under the ink outcondition.z The FINE Cartridge may not be the compatible with this machine. Installthe appropriate FINE Cartridge.Printer error An error requiring servicing might have occurred.Disconnect the cable between the machine and the camera, turn OFF themachine, and unplug the power cord of the machine from the powersupply. After a while, plug the power cord of the machine back in, turn ONthe machine, and then reconnect the camera to the machine. If the sameerror occurs, contact a Canon service representative.Error message on camera Action
