Canon VB-H47 Operation Manual

Also see for VB-S32D: Installation guide Installation guide

92Settings for audio input from the microphone and audio output from the Viewer. Also, registering the sound clip to beoutputted when an event occurs.General AudioSetting the volume of the input/output audio, the type of microphone, and the operation of the built-in microphone for audioinput.[Audio Input]Select whether to use audio input from the microphone. If [Enable] is selected, it is possible to use functions related toaudio input such as [Audio Server] > [Audio Transmission from the Camera] (P. 93) or [Detection] > [Audio Detection] >[Volume Detection] > [Volume Detection Event] (P. 104).If you select [Disable] and click [Apply], the following settings are locked and audio input functions are disabled.– [Audio Server] > [Audio Transmission from the Camera] > [Disable]– [Server] > [RTP Server] > [RTP Stream 1] to [RTP Stream 5] > [Audio Transmission] > [Disable]– [Detection] > [Audio Detection] > [Volume Detection] > [Volume Detection Event] > [Disable][Input Volume]Set the input volume from the microphone.This is applied when [Audio Input] is set to [Enable].[Current Volume Level]When [Audio Input] is set to [Enable], the current volume level is displayed on the status bar.[Low-Cut Filter]When [Audio Input] is set to [Enable], select whether to use the function of cutting the low frequency range of the inputaudio. By selecting [Enable], it is possible to reduce noise, such as wind noise, that occurs when the wind hits microphone,making it easier to hear conversations.By selecting [Disable], environmental noise, such as generated by traffic or crowd, are inputted more accurately.[Audio] > [Audio]Important• Video and audio can be delivered to up to 30 clients. However, when there are many clients or they are connected to the camera overan SSL/TLS connection, when the audio is received from the camera, the video frame rate may decrease or the audio may beinterrupted.• The video and audio may not be synchronized.• If the [Input Volume] or [Low-Cut Filter] setting is changed after setting volume detection (P. 104), review the detection setting.• The audio may be temporarily interrupted, depending on the performance of the computer and the network environment.• The audio may be interrupted if anti-virus software is enabled.• When communication is temporarily interrupted due to reseating the LAN cable, the audio is interrupted. If this occurs, reconnect fromthe Viewer.• The volume, sound quality, etc., may change depending on the characteristics of the microphone used.• Use a speaker with an amplifier to connect to the camera (refer to the “Installation Guide”).S32VEHM4x S32D S820D/S920FS32VE