4-12Installation Conditions1 [Dome]Select whether or not a dome is used. To use thecamera with a dome housing unit, select [Use].2 [LED Setting]Select [Turn Off] or [Turn On] for the LED operationstatus on the camera. Set to [Turn Off] if the optionalindoor dome housing (DR40-C-VB/DR40-S-VB) will beused, if reflected LED light enters the capture area orotherwise interferes with image capture, or if you do notwant to turn on the LED.3 [Image Flip]Select the orientation of the camera image. The factorydefault setting is [Disable] (ceiling mounted). Select[Enable] for installing upright positions.NoteThe LED will light for several seconds when booting even if the[LED Setting] is set to [Turn Off].Camera Position Control1 [Restricted to Presets]Set the camera control preset to [No Restriction] or[Preset Only]. The administrator can limit cameracontrol by non-administrators to preset angles byselecting [Preset Only].2 [Camera Position without Control]Select either [Do not return to Home Position] or[Return to Home Position] as the action when no controlprivileges are requested by users and the homeposition has already been set.When [Return to Home Position] is selected and nousers have control privileges, the camera movesautomatically to the home position. This functionrequires the home position of the camera be set inadvance. Set the home position using Preset SettingTool (P. 5-16).External Input Device 1, 2 / External Output Device 1, 2[Device Name] for external input device/external outputdeviceBe sure to enter each device name in order to identifythe corresponding external device being connected.Enter [Device Name (alphanumeric characters)] usingup to 15 characters (ASCII characters (space orprintable characters) excluding a double quotationmark (“)).NoteThe external device name set here will be shown when the AdminViewer or bundled RM-Lite is used.
