8Before using the Wi-Fi Remote application to remotely control the camcorder, you need towirelessly connect the camcorder (with the transmitter attached) to a Wi-Fi network via anaccess point (wireless router). There are six ways to do so, and the method you use willdepend on the ype and specifications of the access point or device you want to use.Note that using an unprotected Wi-Fi network can expose your data to monitoring byunauthorized third parties. Be aware of the risks involved.If your wireless router supports Wi-Fi Protected Setup (WPS), setup willbe easy and require minimal configuring and no passwords. To check ifyour wireless router has a WPS button and for details about how toactivate the Wi-Fi protected setup, refer to the instruction manual of yourwireless router.Even if your wireless router does not have a dedicated WPS button, it may support WPS usinga PIN code instead. For setup using a PIN code, you will need to know in advance how toactivate the wireless router’s WPS function. For details refer to the instruction manual of yourwireless router.If your wireless router does not support Wi-Fi Protected Setup (WPS), or if you prefer tomanually configure settings or use an Ad Hoc connection to a Wi-Fi enabled device, you canuse one of the four options offered by the Connection Wizard.Searching for Access PointsIf your access point does not support the WPS function or you cannot activate it, you can havethe camcorder search for access points in the area.Manual SetupIf the access point you want to use has stealth mode activated and it cannot be automaticallydetected by the camcorder, you can enter all the necessary settings manually. This requiresmore advanced knowledge of Wi-Fi and network settings.Connecting to a Wi-Fi Network[WPS: Button][WPS: PIN Code][Connection Wizard]COPY