11When the camera is set to mode, connect the camera to an access point. You can saveup to 4 network configuration profiles for different networks and select which one to usedepending on where you plan to use the camera.1Set the camera to mode and openthe [Connection Settings] submenu.[w System Setup] > [Network Settings] >[Connection Settings]The current network configuration will be displayedon the screen. Push the joystick up/down or turnthe SELECT dial to select a different networkconfiguration profile.2Press SET to display the connectionsettings of the selected networkconfiguration.The current connection settings will be displayedon the screen.To use the current settings, select [OK] and pressSET. The rest of the procedure is not necessary.To change the settings, select [Edit], press SETand continue with the next step.3Select the method you wish use to setup the access point connection andpress SET.Refer to the descriptions of each method (A 7)and select the most appropriate one depending onthe characteristics of the access point you plan touse. Continue with the procedure explained in therelevant page.[WPS: Button], [WPS: PIN Code] (A 12)[Search for Access Points] (A 14)[Manual] (A 15)Infrastructure Connection