Canon WFT-E6 Operational Manual

Also see for WFT-E6: User guide Instruction manual Guide Guide Guide

9When the camera is set to mode, connect a Wi-Fi enabled device using a CameraAccess Point connection. Initially, basic default network settings (SSID, password, etc.) aresaved in the camera and you can use these settings to immediately connect a device to thecamera.If you prefer to use different settings, follow the procedure below.1Set the camera to mode and openthe [Connection Settings] submenu.[w System Setup] > [Network Settings] >[Connection Settings]The current Camera Access Point connectionsettings will be displayed on the screen. To changethe settings, press SET. To keep the currentsettings, press the CANCEL button.2To change the [SSID] (network name),select [Input] and then press SET.Enter the SSID (network name) the camera willuse as a Wi-Fi access point using the keyboardscreen (A 10).The network name is needed to connect the Wi-Fienabled device to the camera. If necessary, write itdown.3Select the wireless connection mode(5 GHz band or 2.4 GHz band) and thenpress SET.4Select the channel and then press SET.Available channels will differ depending on thewireless connection mode selected in the previousstep.5Select the encryption method and thenpress SET.If you selected [Open/No encryption], continuewith the procedure to configure the IP addressassignment (A 16). If you selected [WPA2-PSK/AES], continue the procedure to set the password.Camera Access Point Connection