18Initially, basic default network settings for a browser connection are already saved in thecamera. You can check these settings on the status screens (A 21). With the followingprocedures you can change the default settings, if you prefer.[Camera ID] A unique camera identification code that will appear on the BrowserRemote screen. This is convenient if you are using a multi-camerashooting setup.[Port No.] The port number (HTTP protocol) used by Browser Remote. This is usuallyset to port 80, but you can change it if necessary.1Set the camera to mode and openthe [Camera ID] submenu.[w System Setup] > [Network Settings] > [BrowserRemote] > [Camera ID]2To change the camera ID, select [Input]and then press SET.Enter the desired camera ID (up to 8 characters)using the keyboard screen (A 10).3To change the port number, select [PortNo.] and then press SET.Using the default number is recommended.To change the port number, push the joystick left/right to select the digit you wish to change andthen push the joystick up/down to select the digit.After completing all the digits, select [Set] and thenpress SET to confirm.Browser Remote: Camera Settings