42Setting the Time CodeSelecting the Frame SettingWhen recording in a mode other than SD at a frame rate of 24F, you can select between a drop frame ornon-drop frame time code.Open the menu and select [SIGNAL SETUP]. Select the [TIME CODE] submenu and then[FRAME SETTNG]. Select a setting option and close the menu.When you select the [NON DROP] setting or when you select 24F frame rate in SD mode, “NDF” will appearon the side panel display.Selecting the Running ModeWhen recording in a mode other than SD at a frame rate of 24F, you can select the running mode of thecamcorder’s time code. You can enter the initial value for the [FREE-RUN] and the [REC-RUN PS.]settings.[REC-RUN]: The time code runs only when recording.[REC-RUN PS.]: The time code runs only when recording starting from a preset value.[FREE-RUN]: The time code runs regardless of the operation of the camcorder.1. Open the menu and select [SIGNAL SETUP]. Select the [TIME CODE] submenu andthen [COUNT-UP]. Select a setting option and close the menu.[REC-RUN]: Close the menu.[REC-RUN PS.], [FREE-RUN]: Continue the procedure below to set the initial value.2. Select [SET].The hours display flashes.3. Set the time code’s initial value.Turn the SELECT/SET dial to set the value for the hours and press the dial. The next field of the displaystarts flashing. Set the value for the minutes, seconds and frames in the same way.4. Close the menu. About the time code display- [REC-RUN]: The time code will be displayed with an next to it.- [REC-RUN PS.]: The time code will be displayed in blue with a next to it.- [FREE-RUN]: The time code will be displayed in blue with an next to it.- External Time Code: The time code will be displayed in blue with an next to it.- Time Code Hold: The time code will be displayed with an next to it.- Playback: No time code display. When you select [FREE-RUN], the time code starts to run the moment you press the MENU buttonin the middle of the setting, or when you press the SELECT/SET dial after setting the value for“frames” in step 3. To reset the time code to [00:00:00:00], select [RESET] in step 2.MENU( 25) SIGNAL SETUP TIME CODE FRAME SETTNG•DROPMENU( 25) SIGNAL SETUP TIME CODE COUNT-UP•••••REC-RUNRPFEH