Handling rollsCutting the Leading Edge of Roll Paper AutomaticallyIf the leading edge of a roll is crooked or warped, it may cause an error message or printing problems. In thiscase, set Trim Edge First to Automatic or On in the Paper Menu on the Control Panel to have the printer cut theleading edge to make the edge straight after you load a roll.Trim Edge First offers the following options.• AutomaticIf the left and right side of the leading edge of the roll ((a) and (b)) are uneven by 3 mm (0.12 in) ormore when you load the roll, the edge is cut an amount relative to the slant to ensure a straight edge,and scraps are removed. The edge is not cut if the unevenness is less than 3 mm. However, papermay sometimes be cut, depending on the state of the leading edge.• OffThe edge is not cut and scraps are not removed. This setting is Off for most types of paper, by default.For more information, see the Paper Reference Guide. (→P.96)• OnThe leading edge is cut off when you load a roll, and scraps are removed. The amount of paper cutfrom the leading edge varies depending on the type of paper. For more information, see the PaperReference Guide. (→P.96)Follow these steps to change the Trim Edge First setting.1. On the Tab Selection screen of the Control Panel, press ◄ or ► to select the Paper tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.2. Press the OK button.The Paper Menu is displayed.3. Press ▲ or ▼ to select Paper Details, and then press the OK button.4. Press ▲ or ▼ to select the type of paper, and then press the OK button.5. Press ▲ or ▼ to select Trim Edge First, and then press the OK button.6. Press ▲ or ▼ to select the desired setting option, and then press the OK button.This setting takes effect the next time you load a roll.Handling Paper 133
