Network SettingConguring the Printer’s AppleTalk Network SettingsFollow the steps below to congure the AppleTalk network settings.1. Start the web browser and enter the following URL in the Location (or Address) box to displaythe RemoteUI page.http://“printer IP address or name”/Example: http://xxx.xxx.xxx.xxx/2. Select Administrator Mode and click Logon.3. If a password has been set on the printer, enter the password.4. Click Network in the Device Manager menu at left to display the Network page.5. Click Edit in the upper-right corner of the AppleTalk group to display the Edit AppleTalkProtocol Settings page.6. Refer to the AppleTalk Settings Items table to complete the settings.AppleTalk Settings ItemsItem Details Default SettingPhase Type Specify whether to use AppleTalk.If you will use AppleTalk, choosePhase 2.If you will not use AppleTalk,choose Disabled.DisabledName (*1) Specify the object name used byAppleTalk (in up to 31 single-byteor 15 double-byte characters).However, do not use the followingsingle-byte characters: @, *, :,and =.Canon NB-18GB (xxxxxx)Zone (*2) Specify the printer zone name, upto 31 single-byte characters.However, do not use the followingsingle-byte characters: Also avoidusing “*” (which represents thedefault zone) in the middle of astring.**1: The object name you have specied in Name is displayed in Printer Setup Utility (or Print Center)in Mac OS X 10.2.8-10.4. If you use multiple printers in the same zone, assign a unique name toeach printer. By default, the network interface name is “Canon NB-18GB (xxxxxx).” (Here, xxxxxx isthe last six digits of the printer’s MAC address.)*2: If zones have been created on the network, enter the name of the printer’s zone. If there areno zones, leave the asterisk “*” entry (for the default zone) as it is. If you enter a network zonename that does not match created zones, the printer will not be detected by Macintosh computers.Consult your network administrator for information on zone names.7. Click OK to display the Network page.574 Network Setting
