Item Details Default SettingMulticast DNS Serv-ice NameSpecify the printer's Multicast DNS service name. (1–63 charac-ters)This name will be displayed when Bonjour functions are used.Canon iPFxxxx(xxxxxx)7. Click OK to display the Network page.Note• If you specify to configure the IP address using DHCP, BOOTP, or RARP, there must be a server that sup-ports such protocol running in the network.• If you specify to configure the IP address using DHCP, BOOTP, or RARP, the IP address obtained by thismethod is used first. If you cannot obtain the IP address, the address specified in IP Address is used.• It takes up to two minutes to determine whether DHCP, BOOTP, or RARP are available. We recommendclearing check boxes of options you will not use.• If you are using a DNS server, select Enable DNS Dynamic Update and enter the IP Address for DNS serv-ers and DNS domain name in Primary DNS Server Address, Secondary DNS Server Address and DNSDomain Name, respectively.When using an IPv6 IP address1. Start the web browser and enter the following URL in the Location (or Address) box to display the RemoteUIpage.http://printer IP address or name/Example: http://xxx.xxx.xxx.xxx/2. Select Administrator Mode and click Logon.3. If a password has been set on the printer, enter the password.4. Click Network in the Device Manager menu at left to display the Network page.5. Click Edit in the upper-right corner of the TCP/IPv6 group to display the Edit TCP/IPv6 Protocol Settings page.6. Refer to the TCP/IPv6 Settings Items table to complete the settings.TCP/IPv6 Settings ItemsItem Details Default SettingUse IPv6 Activate to enable IPv6. OffUse DHCPv6 Activate when using a DHCPv6 server to acquire theIP address.OffUse a stateless address Activate when using an IPv6-compatible router to ac-quire the IP address.OnUse a manual address Activate when configuring the IP address manually. OffIP Address Enter the printer's IP address. ::Network Setting > Initial Settings >Configuring the Printer's TCP/IP Network Settings With RemoteUI iPF75510774