Chapter 55-3F-5-25.2 Various Controls5.2.1 Controlling the Laser Activation Timing5.2.1.1 Laser Emission ON/OFF Control 0010-7720iR2016 / iR2020 / iR2016i / iR2020iThe purpose of this control is to turn ON/OFF the laser diode (LD) in response to video signals.The DC controller PCB sends laser control signals (CNTRL0, CNTRL1, and CNTRL2), which are used to switch between laser driver operation modes, to the laserdriver IC along with video signals (VDO1, /VDO1, VDO2, and /VDO2). The laser driver IC controls laser emission (ON/OFF) according to the combination ofCNTRL0, CNTRL1, and CNTRL2 signals.The following table shows combinations of laser control signals (CNTRL0, CNTRL1, and CNTRL2).T-5-45.2.1.2 Laser Emission ON/OFF Control 0011-2155iR2016J /The purpose of this control is to turn ON/OFF the laser diode (LD) in response to video signals.The DC controller PCB sends laser control signals (CNTRL0, CNTRL1, and CNTRL2), which are used to switch between laser driver operation modes, to the laserdriver IC along with video signals (VDO1, /VDO1). The laser driver IC controls laser emission (ON/OFF) according to the combination of CNTRL0, CNTRL1,and CNTRL2 signals.The following table shows combinations of laser control signals (CNTRL0, CNTRL1, and CNTRL2).Laser control signal Laser status DescriptionCTL2 CTL1 CTL0 Laser A Laser B0 0 0 OFF OFF Laser control OFF1 1 1 Video signal inputenableLaser beams can be emitted inresponse to video signals.1 1 0 ON OFF Forced emission of laser A (foradjustment in factory)1 0 1 OFF ON Forced emission of laser B (foradjustment in factory)1 0 0 ON ONForced emission of laser A andlaser B (for adjustment infactory)0 1 0 ON OFF APC over laser A0 0 1 OFF ON APC over laser B0 1 1 OFF OFF Forced stop of laser emission[4]Image ProcessorPCBDC Controller PCBJ314J207J206 J205IC5[2] [3][1]
