Chapter 1313-10##0770 [Tx] at time of ECM transmission, no meaningful signal is received after transmission ofEOR-NULL, causing the procedural signal to be transmitted more than specified.##0772 [Tx] at time of ECM transmission, DCN is received after transmission of EOR-NULL.##0773 [Tx] at time of ECM transmission, the procedural signal has been transmitted more thanspecified after transmission of EOR-NULL, or T5 time-out (60 sec) has occurred.##0774 [Tx] at time of ECM transmission, ERR is received after transmission of EOR-NULL.##0775 [Tx] at time of ECM transmission, no meaningful signal is received after transmission ofEOR-MPS, causing the procedural signal to be transmitted more than specified.##0777 [Tx] at time of ECM transmission, DCN is received after transmission of EOR-MPS.##0778 [Tx] at time of ECM transmission, the procedural signal has been transmitted more thanspecified after transmission EOR-MPS, or T5 time-out (60 sec) has occurred.##0779 [Tx] at time of ECM transmission, ERR is received after transmission of EOR-MPS.##0780 [Tx] at time of ECM transmission, no meaningful signal is received after transmission ofEOR-EOM, causing the procedural signal to be transmitted more than specified.##0782 [Tx] at time of ECM transmission, DCN is received after transmission of EOR-EOM.##0783 [Tx] at time of ECM transmission, the procedural signal has been transmitted more thanspecified after transmission of EOR-EOM, or T5 time-out (60 sec) has occurred.##0784 [Tx] at time of ECM transmission, ERR is received after transmission of EOR-EOM.##0785 [Tx] at time of ECM transmission, no meaningful signal is received after transmission ofEOR-EOP, causing the procedural signal to be transmitted more than specified.##0787 [Tx] at time of ECM transmission, DCN is received after transmission of EOR-EOP.##0788 [Tx] at time of ECM transmission, the procedural signal has been transmitted more thanspecified after transmission of EOR-EOP, or T5 time-out (60 sec) has occurred.##0789 [Tx] at time of ECM transmission, ERR is received after transmission of EOR-EOP.##0790 [Rx] at time of ECM reception, ERR is transmitted after transmission of EOR-Q.##0791 [Tx/Rx] while ECM mode procedure is under way, a signal other than a meaningful signalis received.##0792 [Rx] at time of ECM reception, PPS-NULL cannot be detected over partial pageprocessing.##0793 [Rx] at time of ECM reception, no effective frame is received while high-speed signalreception is under way, thus causing time-out.##0794 [Tx] at time of ECM reception, PPR with all 0s is received.##0795 [Tx/Rx] a fault has occurred in code processing for communication.No. Tx/Rx Description
