Chapter 22-35F-2-14222) Connect the host machine's power plug to the outlet, and then turn ONthe main power switch.23) Turn on the environment heater switch.24) Install the environment heater switch cover.2.11 Installing the Deck Heater2.11.1 Checking the Parts to Install 0019-9911iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245NEvery components of the cassette heater unit are supplied as service parts, sohave the following parts on hand.F-2-143T-2-72.11.2 Turning OFF the Power of the Host Machine 0019-9913iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245NBe sure to refer to "Points to Note When Turning OFF the Main Power" ininstallation of the host machine.2.11.3 Installation Procedure 0019-9917iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N1) Disconnect the cable [1] of the paper deck from the host machine.F-2-1442) Hold down the paper deck release grip [1] to release the paper deck fromthe host machine. Hold down the latch plate [2] with a finger to open thecompartment.F-2-1453) Remove the right cover [2] of the paper deck.No. Part name Part number Qty.[1] Heater unit FG6-9651-000 1pc.[2] Power supply code base FG6-1117-000 1pc.[3] Relay harness unit FG6-2957-000 1pc.[4] AC cable FK2-1777-000 1pc.[5] Screw (w/ washer) XA9-0266-000 2pcs.[6] Cable protection bush WT2-5098-000 1pc.[7] Power supply label FS6-8725-000 1pc.[1][3][4] [2][1][2] [3][4] [5] [6][7] [8] [9] [10][8] Screw (RS tight; M4X8) XA9-0628-000 2pcs.[9] Screw (Binding; M4X4) XB1-2400-409 1pc.[10] Plug cover FC6-5776-000 1pc.In order to operate the cassette heater unit, it is required to install thecassette pedestal heater kit.Refer to the corresponding page for its installation procedure.Be sure to attach after installation of the host machine and the paper deck.No. Part name Part number Qty.[1][1]
