Canon imageCLASS D1620 User Manual

Could not connect. The maximum number of devices that can connect to theaccess point has been reached.The machine attempted to connect to a wireless LAN router to which the maximum number of deviceswere already connected.● Decrease the number of devices (clients) that are connected to the wireless LAN router. For information onthe maximum number of devices that can connect, see the instruction manual for the wireless LAN routeror contact the manufacturer.Could not connect using Easy Connection via PC. The device will restart.Connection in Access Point Mode failed due to an error.● Restart the machine, and then, perform again. (P. 458)An error occurred during the procedure for Easy Connection via PC (cableless setup mode).● Restart the machine, and then, perform again. (P. 458)Could not connect using the wireless LAN. Turn the main power OFF and ON,then configure the settings again.A connection failed due to an error while setting wireless LAN connection.● Restart the machine and set again.● If the problem persists even after restarting the machine, check whether the machine is properly installedand ready to connect to the network.Installation/Settings Problems(P. 589)● If the problem persists even after checking the wireless LAN connection, check the security settings of thewireless router.Could not connect using WPS. Wait a moment, then configure the settingsagain.When automatic setting with WPS was attempted, the connection failed due to an error.● Wait for a while, and set again. If the problem persists, check whether the wireless router supports WPS.If WPS is supported:Check whether the machine is properly installed and ready to connect to the network.Installation/Settings Problems(P. 589)If WPS is not supported:Set using another connecting method.Connecting to a Wireless LAN(P. 17)Troubleshooting619