Network Setting (Windows)Specifying the Printer’s Frame TypeTo enable communication between the printer and computers on your network, specify the Ethernet frametype in your NetWare environment.Follow the steps below to specify the frame type by using imagePROGRAF Device Setup Utility or theprinter Control Panel.Note• You can specify the frame type by using RemoteUI if the printer’s IP address is congured.Important• Before specifying the frame type, make sure the printer is on and connected to the network.• For instructions on installing imagePROGRAF Device Setup Utility, see “Installing imagePROGRAFDevice Setup Utility”. (→P.535)Specifying the frame type using imagePROGRAF Device Setup Utility1. Start imagePROGRAF Device Setup Utility.2. In the list of printers, select the printer to congure.3. Choose Protocol Settings from the Printer menu.4. In the NetWare Frame Type list, select the frame type.5. Click ETHERNET II under Frame Type in TCP/IP.6. In IP Address, enter the IP address assigned to the printer, and then enter the subnet mask inSubnet Mask and the default gateway in Gateway Address.Important• You must specify the IP address here to be able to congure NetWare protocol settings usingRemoteUI.7. Click Set.8. Click OK after the Conrmation message dialog box is displayed.9. Exit imagePROGRAF Device Setup Utility.626 Network Setting
