A Drying TimeSpecify the time that the printer waits for ink to dry, as needed. The Between Pages setting is only valid for rolls.• B Between PagesYou can set the time to wait after printing 1 document page until ejecting the paper. Since waiting time is requiredfor ink to dry before a roll is cut, you can deliver paper in the Output Stacker with the ink dried even if CuttingMode is set to Automatic.Setting Item DetailsPrinter Default The setting of the control panel of the printer is applied.Off Paper is ejected immediately after printing completes.30 sec. / 1 min. / 3 min. / 5 min. / 10min. / 30 min. / 60 min.Paper is ejected when the set time elapses after printing completes.• C Between ScansYou can set the time to wait after printing 1 line on a page until printing the next line. Set this to avoid bleeding orcolor unevenness such as when bleeding occurs on a page or when color unevenness occurs during borderlessprinting.Setting Item DetailsPrinter Default The setting of the control panel of the printer is applied.Off The next line is printed immediately after a line is printed.1 sec. / 3 sec. / 5 sec. / 7 sec. / 9 sec. The next line is printed when the set time elapses after a line is printed.* Increase the time according to the occurrence condition of bleeding or unevenness.D Roll Paper Margin for SafetyYou can specify the length of a margin on the leading edge of paper to ensure that paper susceptible to curling is heldfirmly against the Platen.• E Near End MarginSpecify the length of the Near End Margin (the leading edge margin) of the roll, as needed.Setting Item DetailsPrinter Default The setting of the control panel of the printer is applied.3 mm (0.12 in) The document is printed in the standard size.* Select this when you do not have any problems in printing.20 mm (0.8 in) Select this when rubbing against the printhead occurs such as when using paper that tends tocurl.F Cut SpeedSelect the speed of automatic cutting, as needed. You can adjust this setting if paper is not cut well when automaticcutting is used.Setting Item DetailsPrinter Default The setting of the control panel of the printer is applied.High Speed When the Standard setting does not result in cutting the surface cleanly, select this.Standard Select this when you do not have any problems in automatic cutting.Low Speed This helps prevent adhesive from sticking to the cutter and keeps the cutter sharp if you select itwhen using adhesive paper.Paper Detailed Settings Dialog Box iPF6400SUser's GuideWindows Software Printer Driver174