Cannot print over a networkCannot print over a networkCannot connect the printer to the network .............................................................................................................. 962Cannot print over a TCP/IP network ............................................................................................................................ 962Cannot print over a NetWare network ......................................................................................................................... 962Cannot print over AppleTalk or Bonjour networks ................................................................................................. 963Cannot connect the printer to the networkCannot connect the printer to the networkCause Corrective ActionThe Ethernet cable isnot connected cor-rectly to the printer'sEthernet port.1. Make sure the printer is connected to the network with the correct Ethernet cable, and then turn the printer on. Forinstructions on connecting the cable, refer to the Setup Guide.2. Make sure the Link indicator is lit.The top and bottom indicators are lit if the printer is connected via 1000Base-T. The bottom indicator is green if theprinter is connected via 100BASE-TX, and the top indicator is orange if connected via 10BASE-T.If the Link indicator is not lit, check the following points.• Make sure the hub is on.• Make sure the end of the Ethernet cable is connected correctly.Insert the Ethernet cable until it clicks and locks in place.• Make sure there is no problem with the Ethernet cable.If there is any problem, replace the Ethernet cable.• Check the communication mode with the hub.Although the printer normally detects the hub communication mode and transmission rate automatically (in autonegotiation mode), sometimes the hub settings cannot be detected. In this case, configure the connection meth-od manually, specifying the communication mode in use.(See "Configuring the Communication Mode Manually.") ➔ P.694Cannot print over a TCP/IP networkCannot print over a TCP/IP networkCause Corrective ActionThe printer's IP address is not configured correctly. Make sure the printer's IP address is configured correctly.(See "Configuring the IP Address Using imagePROGRAF Device Setup Utility.") ➔ P.697(See "Configuring the IP Address Using the Printer Control Panel.") ➔ P.675The printer's TCP/IP network settings are not config-ured correctly.Make sure the printer's TCP/IP network settings are configured correctly.(See "Configuring the Printer's TCP/IP Network Settings With RemoteUI.") ➔ P.679The computer you are trying to print from is not con-figured correctly.Make sure the computer's TCP/IP network settings are configured correctly.(See "Configuring the Printer Driver Destination (Windows).") ➔ P.678(See "Configuring the Destination in TCP/IP Networks (Mac OS).") ➔ P.690Cannot print over a NetWare networkCannot print over a NetWare networkCause Corrective ActionThe printer's NetWare settings arenot configured correctly.Make sure the printer's NetWare settings are configured correctly. In particular, make sure a valid frametype is selected.(See "Configuring the Printer's NetWare Network Settings With RemoteUI.") ➔ P.687The computer you are trying toprint from is not configured cor-rectly.Make sure the computer's NetWare settings are configured correctly.(See "Configuring NetWare Network Settings.") ➔ P.682The NetWare server and servicesare not configured correctly.Check the following points.1. Make sure the NetWare file server is running.Cannot connect the printer to the network iPF6400SUser's GuideTroubleshooting Cannot print over a network962
