Carelink CL-MC-XE1-IP-Y User Manual
                           | |
Contents
| 
CL-MC-XE1-IP-Y Series (1/2/4 E1) User Manual- 7 -2-7 Getting Start1. Place both CO and CPE CL-MC-XE1-IP-Y devices on a flat work surface.2. Connect the Ethernet cable to the CO CL-MC-XE1-IP-Y device's WAN port and the other end of theEthernet cable to the CPE CL-MC-XE1-IP-Y device's WAN port.3. Ensure that CO and CPE CL-MC-XE1-IP-Y devices are both switched on.4. Connect your computer to the LAN port of the CL-MC-XE1-IP-Y device.5. Check LAN and WAN Ethernet ports LED status as shown in Table2-7.1.6. You may need to set up further parameters via a RS232 console port or a telnet session as describedin section 3-9 “Command Line Interface for Setup”. Examples to configure CL-MC-XE1-IP-Y can befound in Appendix section.Table 2-7.1 LED Indications of CL-MC-XE1-IP-Y 1/2/4-Port E1LED Name State DescriptionPWR Green Power is on.Off No power present.EthernetLink/ActivityGreen Ethernet link is up.Blinking Green Tx/Rx traffic is traversing the port.Off Ethernet Link is down.Ethernet Link Speed Orange 100 MbpsOff 10 MbpsE1 ACT Green E1 port is enabled and traffic is traversing theport.Off E1 port is disabled.E1 ALM Orange E1 link error has occurred.Off No alarm present.ALM Red Alarms raised from any of E1 linkOff No alarm present.www.carelink.com |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine