Manuals database logo
manualsdatabase
Your AI-powered manual search engine

Carelink CL-MC-XE1-IP-Y User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Contents
  1. Table Of Contents
  2. Chapter 1 Introduction
  3. CL-MC-XE1-IP-Y Outlook
  4. Order Information
  5. Chapter 2 Installation Notes
  6. AC or DC Electrical Outlet Connection
  7. Getting Start
  8. Chapter 3 Operating Instructions
  9. Rear Panel
  10. Loopback Mode
  11. Save Configuration
  12. Command Line Interface for Setup
  13. Appendix
  14. B) Script for resetting CL-MC-XE1-IP-Y to default II
  15. C) Script for resetting CL-MC-XE1-IP-Y to default III
  16. D) Script for resetting CL-MC-XE1-IP-Y to default IV
  17. E) Script for resetting CL-MC-XE1-IP-Y to default V
Carelink CL-MC-XE1-IP-Y User Manual Manual pdf 15 page image
CL-MC-XE1-IP-Y Series (1/2/4 E1) User Manual- 12 -PWRBIT: Packets loss occurred at remote Ethernet WAN port.PWSEQNUMERR: Packets received out of sequence at local Ethernet WAN port.JBUFEMP: Jitter buffer empty occurred at the E1 port. (Possible reasons could be due to WAN portEthernet link down or pseudowire ID mismatched.)JBUFOV: Jitter buffer overflow occurred at the E1 port.3-8 Save ConfigurationAfter change the settings of device, please execute csave command to save the new settings to thedevice. This can prevent all of your settings loss if you reboot or power cycle the device.www.carelink.com
/ 27
This manual is suitable for:
CL-MC-XE1-IP-Y
Manuals database logo
manualsdatabase
Your AI-powered manual search engine