Carelink CL-MC-XE1-IP-Y User Manual
                           | |
Contents
| 
CL-MC-XE1-IP-Y Series (1/2/4 E1) User Manual- 17 -CLI Command Descriptioncesfe1mode ch_no en(1/0) Set TDM PW to Transparent E1 (SAToP) or Fractional E1 N x 64k mode(CESoPSN)ch_no: E1 channel number (1~4)enable: 0:disable, 1: enable.EX: ceschmode 1 1 (Set E1 port #1 to Fractional E1 (CESoPSN) mode)cesfe1crc ch_no en(1/0) E1 G.704 CRC4 generation/analyze control for Fractional E1 mode. This settingonly affect E1 ports set to FE1 N x 64k mode, for E1 ports set to Transparent E1mode this setting has no effect.ch_no: E1 channel number (1~4)enable: 0:disable, 1: enable.EX: cesfe1crc 1 1 (Enable G.704 CRC4 generation/analyze on E1 port #1.)cesfe1tsmap ch_no TsMap Set 64k PCM channel number to be transported over the TDM PW for FE1(CESoPSN) mode. This setting only affect E1 ports set to FE1 N x 64k mode, forE1 ports set to Transparent E1 mode this setting has no effect.ch_no: E1 channel number (1~4)TsMap: bit mask for DS0, b31:TS31 ~ b0:TS0EX: cesfe1tsmap 1 x000007FETimeslot #1 ~ 10 of E1 port #1 will be transported over the TDM PW.x000007FE (hexadecimal)=0000 0000 0000 0000 0000 0111 1111 1110 (binary)TS31: the most left bit, TS0: the most right bit, TS0 is used for frame alignment andcan’t be counted in your timeslots and always set to 0.ceschvlanvlpid ch_novlp idSet CESoPSN Channel vlan tagch_no: E1 channel number (1~4)vlp: vlan priority, 0 ~ 7(highest priority)id: vlan id, 0 ~ 0xFFFEx: ceschvlanvlpid 1 7 5 (set E1 port #1 traffic with vlan tag, set priority to 7 and setvlan ID to 5)Alarm Commandalmall Display all alarm status (CESoPSN)AppendixA) Script for resetting CL-MC-XE1-IP-Y to default IScript for setting the device back to default I ( LAN bandwidth is 400 kbps)Script for setting CO site configuration back to default I#Execute global chip initializationgciwww.carelink.com |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine