Carrier 38QHP009E8S Owner's Manual

Contents

051.2 ACCESSORIESThe following accessories are supplied with the unit. The type and quantity may differdepending on the specifications.1.3 INSTALLATION SITE CHOOSING31Name of AccessoriesManualQ‘ty(pc) Shape11Drain outletGasketInstallation plateName of Accessories Q‘ty(pc) ShapeAnchor 5Screw A 51212Screw BRemote controllerRemote controller holderBatteryIndoor Unit- A location which can bear the weight of indoor unit.- Do not install indoor units near a direct source of heat such as direct sunlight ora heating appliance.- A location which provides appropriate clearances as below figure.- Moving parts of appliance must be installed/located at the level not less than 2.3m fromthe floor.Outdoor Unit- A location which is convenient to installation and not exposed to strong wind. If unit isexposed to strong winds it is recommended that a wind baffle be used.- A location which can bear the weight of outdoor unit and where the outdoor unit can bemounted in a level position.- A location which provides appropriate clearances as below figure.Do not install the indoor or outdoor units in a location with special environmentalconditions.Confirm that there is enough room for installation and maintenance.Note: Ensure the spaces indicated by arrows from the wall, ceiling, fence or other obstacles.15cm or more 2.3m or more60cm or more30cm or more12cm or more12cm or more30cm or morePiping is possible in the rear, left, left rear and right direction.200cm or more60cm or morePlug the unuseddrain hole with therubber plugprovided.Cut the knock-outpanel according tothe piping size.knock-out panel1. PREPARING FOR INSTALLATION1Small Filter1. PREPARING FOR INSTALLATION06Magnetic ring(Some units)N** means that according to the actual quantity.ModeTimerTurbo IONLEDON/OFF FanFollowmeSelfcleanGB