10093.2 SPACE REQUIREMENT FOR OUTDOOR UNIT>30cm>30cm>200cm>60cm(Wall or obstacle)Maintain channelAir outletAir inletMPAir inletN>60cmFix with boltSingle Unit InstallationBefore installation, check strength and horizontality of the base so that abnormal sound does not generate.Fix the base firmly with anchor bolts (M10) to prevent it from collapsing.Install the foundation and vibration-proof rubbers to directly support the bottom surface of the fixing leg thatis in contact with the bottom plate of the outdoor unit.3.4 INSTALL THE OUTDOOR UNIT≥100mm100~300mmOutdoor unitVibration-proof rubberAnchor bolt (M10)Drainage (Wide 100mm x Depth 150mm)Mortar Hole (Φ100mm x Depth 150mm)>200 >50 >300 >300 >30>60>200>30Parallel connect the two units or above Parallel connect the front with rear sides.Connect the drain outlet with an extension drain hoseFit the gasket onto drain outlet.Insert the drain outlet into the base pan hole of outdoor unit, and rotate 90 degree to securely assemble them.3.5 INSTALL THE DRAIN PIPE FOR OUTDOOR UNITunit:cm unit:cmBase pan holeof outdoor unitDrain hose(Field supply)GasketDrain OutletThe mounting dimensions vary among different outdoor units.The fixing bolt head diameter should be more than 12mm.WHBDIn regions with snowfall and cold temperatures, avoid installing the outdoor unit in areas where itcan be covered by snow. If heavy snow is expected, a field supplied ice or snow stand and/orfield supplied-installed wind baffle should be installed to protect the unit from snow accumulationand/or blocked air intake.CAUTION3.3 OUTDOOR WIRE CONNECTIONRemove the electrical cover and cable clamp by loosening the screws.Connect wires to the outdoor terminal block by same sequence to indoor unit.Electric coverWire downwards to preventwater entering control box.L N STerminal BlockCable Clamp3. OUTDOOR UNIT INSTALLATION3. OUTDOOR UNIT INSTALLATION3.1 OUTDOOR UNIT MOUNTING DIMENSIONAOutdoor Unit Dimentsion (mm) Mounting Dimentsion (mm)W H D A B333554800 515 340Outdoor Unit38QHP009E8S38QHP012E8SGB