Carrier 38QHP009E8S Owner's Manual

Contents

0807Note:The installation plate is fixed with a screw for the conve-nience of shipment, please remove the screw first beforeinstallation. (see figure)The mounting plate will look like one of the figuredepending on the unit size.The holes for fixing anchors should be 5mm.ScrewStep 1: Determine Wall Hole PositionStep 2: Attach Mounting PlateStep 3: Drill Wall HoleFix the mounting plate horizontally and level on the wall with fiveor more A-type screws.Install The Mounting PlateDrill Hole In The Wall IndoorWallOutdoor5-7mmStep 4: Connect PipeL N SStep 5: Connect Wire Step 6: Prepare Drain HoseSTEP 8Indoor Wire Connection1. Lift the indoor unit front panel.2. Open the indoor unit electrical cover with a screwdriverthrough the hole, remove the terminal block cover byhand and remove the cable clamp by loosening thescrews3. Pass the connecting wires from the back of indoor unitand connect to the indoor terminal block.Front panelThe drain line must not have a trap anywhere inits length, must pitch downwards, and must beinsulated up to the outside wall.DrainageDo not put drain end into waterProper Do not form a riseStep 7: Wrap Pipe and CableStep 8: Hang the Indoor Unit1. Run refrigerant lines through hole in the wall.2. Hang indoor unit on upper hook of mounting plate,then push lower part of indoor unit up on wall to lowerhook.3. Move indoor unit from side to side, up and down tocheck if it is hooked securely.Hang The Indoor UnitFor proper orientation of the refrigerant piping,electrical cable and drain lines, refer to below Fig:- Place the drain hose below the refrigerant piping.- Make sure that the drain hose is not heaved orsnaked.Wrap The PipeIndoor unitElectricalcableDrain hoseHeat insulationtypeRefrigerant pipingPipe roomPonding box2.1 INDOOR UNIT MOUNTIN PLATE 2.2 INSTALLATION PROCESS2. INDOOR UNIT INSTALLATION 2 INDOOR UNIT INSTALLATIONElectrical coverOpen the coverfrom this hole Connector for wired controller(optional,come out from display box) 30WedgeDrill a 65mm or 90mm(depending onmodels) hole on the wall which isslightly tilted towards the outside.The connector parts of connective pipe mustbe placed outside of room.CAUTIONIndoor unitoutline 895435435.5217460242.545150258wall hole65232.545 45wall hole65298Unit: mmNote: When the gas side connective pipe is Ф16mm(5/8in) or more, the pipe hole should be 90mm(3.54in).Wire box coverScrewScrewTerminal blockcoverCable clampGB