Carrier 50FF Series Control Manual

Also see for 50FC Series: Installation, operation and maintenance instructions Controls, Start-Up, Operation and Troubleshooting User manual Service and maintenance instructions Installation, operation and maintenance instructions

Contents

Carrier 50FF Series Control Manual Manual pdf 6 page image

62 - USER INTERFACES2.1. Graphic terminal (standard)Keys and combinations (quick guide)Key FunctionAlarm There is/are active alarm(s) if the key isilluminated red.By pressing the key once, the description ofthe first alarm will be shown. By using theup/down keys, the other alarms stored inthe memory can be consulted. By pressingthis key for a second time, the alarm(s) willbe reset.If no alarm is active, the message “No alarmactive" appears.Prg This key allows access to the MAIN MENU.All the screens of this control can be selectedfrom this menu.The key will light up in orange.Esc To exit any screen, pressing this key returnsthe user to the start screen of the previousmenu.From the initial screen, if keeping this keypressed for a few seconds, access is givento a group of help screens with informationon the key or key combination that enableperforming the most important controlfunctions.Esc+DownBy pressing both keys simultaneously for afew seconds, it’s possible to change of unitin the pLAN network.UpDownThese keys enable consulting the informationdisplayed on-screen by going forward orback.They can also modify values.By pressing both keys at the same time,direct access is gained to the group ofscreens E. INPUTS/OUTPUTS (belongingto the MAIN MENU).Enter This enables confirming the modified values.By pressing the key once, the cursor isplaced on the first screen parameter.Pressing the key again confirms the adjustedparameter value and it then proceeds to thenext parameter.Prg+EnterThe unit is switched on or switched off bypressing both these keys at the same timefor a few seconds.This action is equivalent to the On/Off fromthe screen A. GENUNIT (belonging to theMAIN MENU).Prg+UpHEATING mode (winter) is selected bypressing both these keys at the same timefor a few seconds.Prg+DownCOOLING mode (summer) is selected bypressing both these keys at the same timefor a few secondsAlarm+DownThe language of the screens is selected bypressing both these keys at the same timefor a few secondsDimensions:Length: 156 mmWidth: 82 mmDepth: 31 mmFeatures● LCD FSTN display (132 x 64 pixel), backlit in blue.● The screen provides detailed explanations of control in easy tounderstand English. No decoding is required.● Only 6, large, easy-to-use buttons are required to maneuverthrough the entire menus.First run of the softwareOn the first run of the software installed on the control, the followingscreen appears on the terminal, informing about the installationof the values by default:The screen that appears later indicates that it is necessary to resetthe terminal to confirm installation:When you switch on the power again, the terminal loads the initialscreen, showing:● The unit number in the pLAN network (U01 indicates that theunit is the master in the pLAN network or a stand-alone unit).● The measured indoor temperature (Ind.T).● The measured outdoor temperature (Out.T).● The default installation language. The available languages are:Spanish (ES), French (FR), English (EN), Italian (IT), Turkish(TR), and German (AL).● The time and date.WarningINITIALIZATIONDefault installationrunning...Please waitWarningINITIALIZATIONCOMPLETEDSwitch-off and back onthe controllerU01 Ind.T: 00.0ßCOut.T: 00.0ßC00:00 EN 00/00/00