Carrier 50TCQD14 Installation Instructions Manual

Also see for 50TCQD: Installation instructions

Contents

13FILTER ACCESS PANELINDOOR COIL ACCESS PANELC10004Fig. 11 -- Typical Access Panel LocationsEconomizerCut Plastic Ties(2) PlacesRemove Hood PartsC10005Fig. 12 -- Economizer WiringHood PartsPlastic Tie WrapQty (2)Screws for Metal TrayQty (2)C10006Fig. 13 -- Damper AssemblyTwo Position Damper Hood Removal and Setup --Factory Option —1. The hood is shipped in knock--down form andassembled to a metal support tray using plastic stretchwrap. Located in the return air compartment, theassembly’s metal tray is attached to the basepan andalso attached to the damper using two plastictie--wraps.2. To gain access to the hood, remove the filter accesspanel. (See Fig. 11.)3. Locate the (2) screws holding the metal tray to thebasepan and remove. In order to remove the screws, itmay be necessary to remove the panel underneath thetwo--position damper. Remove the two screws. Locateand cut the (2) plastic tie--wraps securing the assemblyto the damper. (See Fig. 13.) Be careful to not damageany wiring or cut tie--wraps securing any wiring.4. Carefully lift the hood assembly (with metal tray)through the filter access opening and assemble per thesteps outlined in Economizer Hood and Two–PositionHood.5. If removed, reattach the panel under the damper.Economizer Hood and Two--Position Hood —NOTE: If the power exhaust accessory is to be installedon the unit, the hood shipped with the unit will not beused and must be discarded. Save the aluminum filter foruse in the power exhaust hood assembly.1. The indoor coil access panel will be used as the top ofthe hood. If the panel is still attached to the unit, re-move the screws along the sides and bottom of thepanel. See Fig. 14.SIDEPANELINDOORCOILACCESSPANELINDOORCOILACCESSPANELCAULKHERETOPPANELRAIN DEFLECTORSC10007Fig. 14 -- Indoor Coil Access Panel Relocation2. Swing out indoor coil access panel and insert thehood sides under the panel (hood top). Be careful notto lift the panel too far as it might fall out. Use thescrews provided to attach the hood sides to the hoodtop. Use screws provided to attach the hood sides tothe unit. See Fig. 15.