Carrier AQUAFORCE 30XW150-400 Operation & Service Manual

Contents

6Table 1 — Setup MenuSETUP MENU BUTTON FUNCTIONREGIONALThis button specifies the time and date format and the base unit of measure. Time display can be configured as12-hour AM/PM setting or as a 24-hour setting. The date can be formatted in one of 3 settings, MM-DD-YYYY (Month-Day-Year), DD-MM-YYYY (Day-Month-Year), or YYYY-MM-DD (Year-Month-Day). Units of measure can be either US(English) or Metric (SI).LANGUAGEThis button selects the active language and font of the display. Available languages are English and Spanish (Espanol).If a preferred language is not available, additional software for the Main Base Board (MBB) and the Touch Pilot™ dis-play are required. Contact your Carrier representative for instructions and software.CONTRASTThis button adjusts the LCD contrast. Press and hold the [MOON] button to increase/darken the contrast or the [STAR]button to decrease/lighten the current contrast.NOTE: Touching the screen anywhere for 5 seconds while powering-up will prompt the user to restore contrast andcalibration settings to factory defaults.BACKLIGHT This button specifies whether backlighting should be kept on at all times or turned off during inactive periods.CALIBRATE This button is used to adjust the LCD touch screen calibration. Touch the screen in the circular targets located first inthe upper left and then in the lower right corner of the screen to adjust.PASSWORDSThis button is used to configure the limited and full logged-in access system passwords. In order to change passwords,the user must be logged in with full access to view and change the passwords. All passwords must consist of 4-digits,which can be entered using the numeric keypad. Access levels and associated privileges are as follows:Limited Logged-in Access - Provides the user with read/write access to all available tables (except service configura-tion tables, where the user will not be permitted to modify point data, and Group Display tables, where the user will notbe permitted to add points.) This access level also provides read/write access to all Touch Pilot display setup propertiesexcept Display, CCN, and Password.Full Logged-in Access - Provides user with read/write access to all available tables for the attached device and allTouch Pilot display properties.If the user does not log in, read-only access to all tables is allowed. The user will be prompted to log in when attemptingto access password-required functions.DISPLAYThis button is used to view the description data and part number from the Ctlr-ID Table and to specify the OperatingMode. The Operating mode can be configured for Equipment mode or Network mode. For Touch Pilot displays that arestandard with the unit, Operating mode should not be changed from Equipment mode. Equipment mode providesaccess only to the chiller’s MBB via the Local Equipment Network (LEN) Bus. For remote access, a remote Touch Pilotdisplay can be set to Network mode. Network mode provides access to all devices on the CCN (Carrier Comfort Net-work ® ) bus.NOTE: When changing the operating mode, a power cycle is required in order for the new operating mode to takeeffect. The user should view and correct the following CCN data: address and baud rate, alarm acknowledger, andbroadcast acknowledger designation.CCN This button is used to configure the bus and element numbers and the baud rate of the control on the network.Fig. 6 — Setup Menu Displaya30-4474