Carrier i-Vu XT Router Installation And Startup Manual

Also see for i-Vu XT: Installation and startup guide Installation and startup guide

i-Vu® XT Router (drv_gen5) CARRIER CORPORATION ©2022Installation and Start-up Guide 18 All rights reservedTo wire to a BACnet MS/TP networkAn MS/TP network can be wired to either Port S1 or Port S2.1 Turn on the i-Vu® XT Router's power.2 Check the communications wiring for shorts and grounds.3 Connect the communications wiring to the Port S1 or Port S2 screw terminals labeled Net +, Net -, andShield.NOTE Use the same polarity throughout the network segment.4 If you are using Port S1, and the controller has a Port S1 Configuration rotary switch, set it to 1.NOTE If Port S1 is not being used for any network, set this rotary switch to 0.5 If the i-Vu® XT Router router is at either end of a network segment, set the port's End of Net? switch to Yes.NOTE The router’s End of Net switch applies network termination and bias. See the Open Controller NetworkWiring Guide.6 Turn on the router's power.7 To verify communication with the network, get a Module Status report in the i-Vu® interface for a router onthe MS/TP network.NOTE This step requires that you have discovered and uploaded the router in the i-Vu® application.