i-Vu® XT Router (drv_gen5) CARRIER CORPORATION ©2022Installation and Start-up Guide 20 All rights reservedThe driver properties pages in the i-Vu® application are the same controller setup pages that you access byconnecting to the Service Port.NOTES○ The Home Network portion of the Connections > Device tab is available only by connecting to theService Port and not through the driver properties.○ Some properties, such as the home network settings, cannot be changed in the i-Vu® driver interface.This prevents losing communication to the router. You can change those settings by connecting directlyto the Service Port.After you download the driver to the i-Vu® XT Router, you may want to change the driver's properties in the i-Vu®interface to suit your application.1 On the i-Vu® navigation tree, right-click the i-Vu® XT Router and select Driver Properties from the drop-downlist.2 Select Driver > Settings tab to open the controller setup pages, which are detailed below.Connections tabsUse these pages to set up communication with the i-Vu® XT Router. The fields are editable when the setup pagesare accessed by connecting directly to the Service Port. Some of those fields will not be editable when you accessthem through the i-Vu® system driver properties.Device tabTypically, you define the information on the Device tab in the Service Port controller setup interface and thenconfigure the same information in the i-Vu® interface. Except for the Home Network, you can adjust the settingson the Device tab in the i-Vu® system.NOTE Carefully plan your addressing scheme to avoid duplicating addresses. If third-party devices are integratedinto the system, make sure your addresses do not conflict with their addresses.The Device > Home Network tab is autopopulated based on what is set for the home network. Refer to theNetwork Parameters listed in the appropriate section based on the home network you selected.Adjusting driver properties and controller setup through the Service Portor the i-Vu® interface