Carrier i-Vu XT Router Installation And Startup Manual

Also see for i-Vu XT: Installation and startup guide Installation and startup guide

i-Vu® XT Router (drv_gen5) CARRIER CORPORATION ©2022Installation and Start-up Guide 25 All rights reservedIPv6 Network Interfaces--- IPv6 Network Interfaces --- System message showing the setting for IPv6, including the display name,interface name, set address, Link-Local, Zone Index, MAC address, etc..BBMD If this network interface will be used to access BBMDs, set the BBMD tables byusing the BBMD buttons.• Import BBMD—Import BBMD tables in the specified format. See "Setting upBACnet Broadcast Management Devices (BBMDs)" in SiteBuilder or i-Vu®Help.• Export BBMD—Export the BBMD table that is in the controller to use forstorage, viewing, or troubleshooting.BACnet/EthernetHome networkorSet as homeThis is typically the network that is communicating with the building automationsystem's application. This sets the BACnet Address of the Device Object. If theport is Enabled, the user can set this port as the home network to identify it asthe connection to the i-Vu® application.Click Disable if you want to disable the port from use.Network Number The network number for the BACnet/Ethernet network. This number must beunique for the system.NOTE When downloaded from the i-Vu® application, these numbers match thoseset using SiteBuilder.MAC Address A factory-assigned Ethernet MAC AddressBACnet/SC Port tabNOTE Since BACnet/SC runs on your IP network, you must configure the router’s IPv4 or IPv6 addressinformation on the Gig-E Port tab. If the router will not be routing to IP devices, you can Disable those ports afterconfiguring them.The Connections > BACnet/SC Port tab provides hub status information plus the ability to configure the itemsdescribed in the table below for up to two Secure Connect ports.Network Number Specify a number for the BACnet/SC network or set to 0 if the port is not used.The network number is 0 by default.NOTE When downloaded from the i-Vu® application, these numbers match thoseset using SiteBuilder.Address The Virtual MAC address of the router on the BACnet/SC network. It is the hexrepresentation of the Device Instance found on the Connections > Device tab.NOTE If the Device ID of the router is zero (not recommended), a ’01’ will beassigned to the third octet of this address because zero addresses are not validon a BACnet/SC network.Connection State The status of the router’s connection as a client on the BACnet/SC network.