E-35Important!Always make sure to first remove the 970 from the Ethernet Cradle whenswitching the selector switch.Water or other liquids on the data communication or power supply terminals canlead to an electric shock or fire. Note also that soiling on the terminals will impairthe connection, leading to reduced power supply and communication functionality.As a safety precaution, disconnect the AC adapter before wiping the datacommunication and power supply terminals clean with a dry cloth or cotton bud.Never short out the power contacts of the Ethernet Cradle. This can damage theEthernet Cradle.Do not subject the Handheld Terminal and Ethernet Cradle to vibration orimpact during communication. This can cause communication to be interrupted.When loading the DT-970, fit it securely in place and check that the green powerindicator LED on the front of the Ethernet Cradle is lit.The DT-970 must be inserted correctly to draw power and communicatesuccessfully.Always cap ports that are not being used. Using the Ethernet Cradle while theports are uncapped can cause damage.Do not pick up the DT-970 while it is mounted in the Ethernet Cradle. Doing somay result in the Ethernet Cradle being accidentally dropped, causing injury ordamage.If the Ethernet Cradle will not be used for an extended period, set the powerswitch to OFF.Specifications1. LAN SpecificationsCommunications protocol: IEEE 802.3Media type: 10base-T/100base-TX auto-switched2. USBProtocol: USB Ver2.0 Full speedTransmission rate: 12Mbps (max.)3. Power SupplyPower Source: AC adaptor (AD-S42120C-N5)Consumption Current: 12V DC approximately 0.3AOutput to Handheld Terminal: 5V DC 0.5A (max.)USB Host Output: 5V DC 0.5A (max.)4. AC AdaptorModel: AD-S42120C-N5Input: 100V to 240V AC 50/60Hz 1.2AOutput: 12V DC 3.5A5. Dimensions and WeightDimensions: Approximately 94(W) × 84(D) × 107(H) mmWeight: Approximately 280g6. Operating EnvironmentTemperature: 0°C to 40°C (32°F to 104°F)Humidity: 30% to 80% RH (non-condensation)••••••••