EnglishPlaying the Digital KeyboardE-11You can use the voice pads to sound various sound effects oreven sounds you have sampled (page E-19). Use the voicepads to add something extra to your performances.1. Press bq.2. Press cs and ct at the same time to enable thevoice pads.• Pressing cs and ct at the same time again will disablethe voice pads.• Be sure to make sure the voice pad function is enabledbefore performing the next step. While voice pads aredisabled, buttons bt through co function asregistration memory buttons (page E-48). Performingthe following step with voice pads disabled will changethe setup of the keyboard (tone number, rhythmnumber, etc.).3. Press a voice pad (1 through 5, ck through co)to sound what is assigned to it.There are four sets of voice pad sounds numbered1 through 4 (see below). Each press of bt cycles throughsound sets 1 through 4.Example: When Set 2 is selected• While a sound set number is displayed, you can change itusing bs (10-key). If you do not perform any operation for afew seconds after the indicator appears, the display willreturn to the previous screen automatically.Using the Voice PadsLit when onPad 1 Pad 2 Pad 3 Pad 4 Pad 5Set 1 VOICE 1(Tone 571)*1VOICE 2(Tone 572)*1VOICE 3(Tone 573)*1VOICE 4(Tone 574)*1VOICE 5(Tone 575)*1Set 2 Set 1 at various pitches*2Set 3 Same as Set 1 Set 1 sound, repeated*3Set 4 APPLAUSE GUNSHOT BONGO CONGA TAMBOURINE*1: If you performed melody sampling (page E-20) andassigned the results to these tone numbers, the pad willoutput the sampled sound.*2: Pad 1: Perfect fifth up; Pad 2: Perfect fifth down;Pad 3: Same as Set 1; Pad 4: Starting from a major thirddown, gradually raises the pitch; Pad 5: Starting from oneoctave up, gradually lowers the pitch*3: Pad 3 gradually raises the pitchbt ck cl cm cn coP a d S e t