Device Search Software1133. In the Device Search application, click the Device Search button. See Figure 101: DeviceSearch Application.4. If the Windows Firewall is enabled, a security alert window will pop up. Do the following:a. Click Unblock to continue. Latitude users should consult the Latitude InstallationInstructions on disabling the Windows Firewall.Figure 102: Windows Security Alertb) Click Device Search again. All the discovered IP devices will be listed in the page, asshown in the figure below. The camera’s default IP address is automatically set bythe DHCP server.5. Right-click on the camera whose network property is to be changed. From the menu thatopens, select Network Setup. The Network Setup dialog is displayed.Tip:Record the camera’s MAC address for future reference.6. To access Device Search, do one of the following:a) For DHCP (not supported by Latitude):i) Select DHCP. Do not use for Latitude.ii) Click Apply. When prompted with instructions to search again after one minute,click OK.iii) After one minute, click Device Search.b) For Static IP (recommended for Latitude users):i) Select Static IP (preferable for security and Latitude users). In the IP Address,Gateway, and Netmask, enter the respective LAN/VLAN (optional DNS) values.ii) Click Apply. When prompted with instructions to search again after one minute,click OK.iii) After one minute, click Device Search. The communication settings should nowbe changed and ready to install the camera on the network. Access it either viathe browser-based viewer or Latitude NVMS.
