Installation155.6.2 Mounting the CM-3211/4221-00/10/10-I Indoor Camera1. Do one of the following: For drilled wall or ceiling mounting:a) Use the base plate as a template, mark with a pointed pencil, the mounting surfacethrough the plate holes where the four screw holes will need to be drilled(see Figure 12).Caution:Before marking and drilling the holes, ensure that the base plate alignment is orientedcorrectly so that the required camera field of view can be achieved when the system isassembled.Figure 12: Base Plate Used as a Template to Mark Drilling Locationsb) In the marked locations, drill each hole using a drill-bit of a slightly smaller diameterthan the supplied screw anchors (molly-plug anchor). You want to achieve a snuginsertion so that the plug expansion holds firm after the screws are screwed in.c) Fully insert the supplied anchors into drilled holes. You may need to tap them flushwith the wall using a hammer.• For installing on a 4S recessed electrical box:a) Have a qualified installer (check your local electrical codes) rough-in the 4S recessedelectrical box and run the wires and power (if not PoE) through the wall/conduits tothe box location.b) Ensure that the box is sufficiently sturdy (attach to the wall stud, ceiling joist, orreinforced surface as needed) to securely hold the weight of the camera.• For bracket, pole and pendant installations, follow the hanging device installationinstructions.2. If running the cables through the back, thread the power and Ethernet cables and any otherwires (such as a relay output, alarm input, audio in, or audio out) through the back wireentry. If you are not wiring from within the wall, you can run the wires through the slot onthe side of the Mini-Dome. Punch out the half circle slot and run the wires through this slot.
