Using the DNA Utility to Search and Access the Camera215. If there are devices located on a separate VLAN, the devices must be added manually.Click Add Device Manually from the Operational Toolbar and add the devices.6.3 Main ScreenThe DNA main screen contains four sections, as seen in the following figure:Figure 19: DNA Main Screen6.4 Navigation BarThe callouts on the screen are explained below:1. Navigation Bar: Located at the top of the screen. Includes tabs and dropdown menus toperform actions.2. Operational Toolbar: Located below the Navigation Bar. Used to refresh discoveredunits, filter connected devices for easy operation, and to add a device manually.3. Discover List: Occupies the center of the screen. Displays a list of discovered deviceswith partial device information.4. Status Bar: Located at the bottom of the screen. Displays current device status, includingscanning time, status, and the number of discovered units.The Navigation Bar contains tabs for all the actions needed to configure and manage attacheddevices. If no devices have been discovered, all the tabs are gray (disabled).After a device has been discovered, the tabs for functions which it supports are enabled and colored,as seen in the following Figure:To define the device on which to perform an action, the user must select the device from theDiscover List. The user can select more than one device, in which case the action will be done on allselected devices.
