25VCR OPERATIONTo Delete Channels Manually To delete memorized channels: This feature is useful if your cable signal goes out because it allows you to switch to a regularantenna for alternate television reception. This feature is useful if your cable signal goes out. It allows you to switch to a regular antenna foralternate television reception. Use this option to change the VCR ’s output channel.The default is channel 3.1 Press [VCR], then press [SETUP] and select“CHANNEL SET”. Select “Add/RemoveChannels”.ADD/REMOVE CHANNELSChannel 02is now REMOVED.M EMORIZING TV C HANNELSSelecting cable or antenna viewingTo set the signal type:Press [ENTER] to toggle the setting between CABLEand ANTENNA in the CHANNEL SET screen.When the desired signal type is displayed, press[SETUP] twice to exit.CHANNEL SETAuto Channel SearchAdd/Remove ChannelsSignal Type: CABLECable Box SetupChannel Change: CH3To Set Cable BoxTo Set Output ChannelPress [VCR], then press [SETUP] and select“CHANNEL SET”. Select “ChannelChange” (or “RF Output”).Press [ENTER] to set the RF Output channel toCH3 or CH4.Press [VCR], then press [SETUP] andselect “CHANNEL SET”.Select “Cable Box Setup”.1Select “Cable Box Channel”.Enter the channel number which matchesto the output of the Cable Box.2 CABLE BOX SETUPOn what channel doesthe VCR receive signalsfrom the cable box?(usually 3, 4 or video)- -CHANNEL SETAuto Channel SearchAdd/Remove ChannelsSignal Type: CABLECable Box SetupChannel Change: CH3CHANNEL SETAuto Channel SearchAdd/Remove ChannelsSignal Type: CABLECable Box SetupChannel Change: CH3(RF Output)2 Select the desired channel and delete it.Use the [0-9] buttons to select the desired channel to delete.When [œ ] is pressed, “ADDED” under the channel number changes to“REMOVED”.3 To check the deleted channel, press [CH+/–] on the remote control.Downloaded From DvDPlayer-Manual.com Daewoo Manuals