36Recording CassettesTimer recording using ShowViewn For timer recordings, clock, date, and stations must be set correctly.n Load a cassette with its safety tab in place and with sufficient free space for the recording.Call the ShowView menu.From your TV magazine, type in the number next tothe programme you want to record ...... and confirm.1 Decide if you want to record "ONCE", "WEEKLY" or"DAILY"...... and confirm.2 If you wish to make changes:Move to the position you want to change using the[< / >] buttons.Change the setting using the [< / >] or [number]buttons. If all setting are ok, press [OK], till you see“OK: CONFIRM” in the bottom line.Confirm.3 Switch your player off.0-9:SHOWVIEW NUMBER< :CORRECTOK:CONFIRM SETUP:ENDSHOWVIEW83077----HOW OFTEN DO YOU WANTTO RECORD THIS PROGRAM?PR+/-:SELECTOK:CONFIRM SETUP:ENDTIMER PROGRAM (ONCE)PR 03START TIME 21:20END TIME 22:20START DATE 14/10(SAT)TAPE SPEED SPVPS/PDC ONPR+/-:SELECT (AV1/AV2)0-9 : SETUP (PR)> :CORRECTOK:CONFIRM SETUP:ENDONCEWEEKLY(ONCE A WEEK)DAILY(MON-FRI)DAILY(MON-SAT)DAILY(MON-SUN)• VPS/PDC is a service provided by some stations to enable you to perform timer recordingsprecisely even if the broadcaster delays the start time of the programme slightly. The time youenter is the VPS/PDC time so must be correct. Not all stations offer VPS/PDC, in which case theplayer will start at the time you enter and not the actual start time of the programme.If you wish to start recording at a specific time without it being adjusted by the VPS/PDC systemin the event of a delay, switch VPS/PDC off otherwise the player will not record.• If you don’t have the ShowView numbers see next page for the normal timer.• If you have made a mistake, move back to the relevant position with the < button and changethe setting.• If there is no programme location displayed under “PR” in the change menu, the player doesn’tyet know the location number for the programme you want. Type it in and this will be stored forlast recordings.• If you wish to record from a satellite receiver, select under “PR” the satellite programme locationor AV (1/2) (depending on the connection with the antenna cable or the SCART-cable). Leavethe satellite tuner switched on and to the programme you want.• Should programming overlap, you get a warning.• To cancel the recording press the button (stop) more than 5 seconds.• ShowView is a trademark applied for by Gemstar Development Corp.. The ShowView system ismanufactured under license from Gemstar Development Corporation.C H E C K U P !DVD-Video(PAL) 02.3.15 5:44 PM ˘ ` 36