Parameter FunctionAlarm Out Please select corresponding alarm output channel when an alarmoccurs. You need to check the box to enable this function.Latch The alarm output can delay for the specified time after an alarm stops.The value ranges from 1s to 300s.ShowmessageSystem can pop up a message to alarm you in the local host screen ifyou enabled this function.AlarmuploadSystem can upload the alarm signal to the centre (Including alarmcentre.SendEmailIf you enabled this function, System can send out an email to alert youwhen an alarm occurs.Buzzer Check the box here to enable this function. The buzzer beeps when analarm occurs.4.8.3.6 Alarm OutputFrom main menu-> Setup->Event->Alarm output, it is to set alarm output mode. See Figure 4-71.Figure 4-714.8.4 Storage4.8.4.1 ScheduleFrom main menu-> Setup->Storage->Schedule, you can go to the schedule interface. In this interfaces,you can add or remove the schedule record setup. See Figure 4-72.There are five record modes: Regular, motion detect, alarm and MD&alarm, and intelligence. There aresix periods in one day.You can view the current time period setup from the color bar. Green color stands for the general record/snapshot. Yellow color stands for the motion detect record/snapshot. Red color stands for the alarm record/snapshot. Blue color stands for MD&alarm record/snapshot. Orange color stands for intelligent record/snapshot.184
