Daihatsu 1997 Terios J100 Service Manual
                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                 | |
Contents
| 
CHASSISBRAKE FLUIDCHANGEWARNING:∑ Do not mix the different kind and manufacture of brake fluid.Recommended brake fluid:FMVSS116 DOT3 or SAE J1703CAUTION:∑ If the brake fluid is spilled inadvertently over the paint finish surface of the vehicle or the resin madepart, immediately wipe off the brake fluid and flush with fresh water.∑ Be sure to follow the draining order of each wheel cylinder. The draining should be performed fromthe farthermost wheel cylinder from the brake master cylinder, one by one.MA–261. Remove the brake bleeder plug cap.2. Connect the suitable bleeder hose to the bleeder plug.3. Prepare a suitable container and connect one end of thebleeder hose in the container.4. Depress the brake pedal and have a person hold it in adepressed state.5. Slacken the bleeder plug to drain the brake fluid by anoth-er person and tighten the bleeder plug temporarily.6. Repeat the steps 4 to 5 until the brake fluid in the reservoirtank becomes zero.However, at this state be very careful not to suck the airinto the brake line, except cases where draining of thebrake fluid is required.7. Replenish the new brake fluid into the reservoir tank andmaintain the brake fluid level in the reservoir tank at theMAX level during the following operation.8. Drain the old brake fluid or air from each brake line start-ing from the farthest wheel cylinder from the master cylin-der one by one following the manner mentioned in thesteps 4 to 5 repeatedly.9. Tighten the air bleeder plugs to the specified tighteningtorque.Tightening Torque: 6.9 - 9.8 N·m (0.7 - 1.0 kgf-m)10. Ensure that no air exists in the brake line by depressingthe brake pedal firmly.If air is remaining in the brake line, perform the air bleed-ing by following the procedure described in the steps 4 to5 repeatedly, until air will be discharged. Then, tighten thebleeder plug to the specified tightening torque.11. Install the brake bleeder plug cap.FrontRearJMA00072-00000JMA00073-00056JMA00074-00057JMA00075-00058 |
Related manuals for Daihatsu 1997 Terios J100
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine