BO–91ACCELERATOR PEDALCOMPONENTSINSPECTION OF ACCELERATOR PEDALEnsure that the accelerator pedal operates smoothly without being caught or interference.If any problem is found, replace the damaged accelerator pedal related part, as required.REMOVAL1. Disconnect the accelerator cable assembly from the accelerator pedal.2. Remove the accelerator pedal support bracket by removing the attaching bolt.3. Remove the accelerator cable assembly after disconnecting the cable from throttle body side (Refer tothe EM section.)DISASSEMBLY1. Remove the retainer from the accelerator pedal.CAUTION:∑ Never reuse the removed retainer again.2. Pull out the accelerator pedal slightly. Then, unlock the accelerator link rod return spring from the accel-erator pedal.3. Remove the accelerator pedal from the accelerator pedal support bracket.4. Remove the accelerator link rod return spring and bushs from the accelerator pedal support bracket.5. Remove the cushion from the accelerator pedal support bracket.ASSEMBLY1. Install the cushion from the accelerator pedal support bracket.2. Thinly apply the chassis grease to accelerator link rod return spring and bushs.3. Install the accelerator link rod return spring and bushs to the accelerator pedal support bracket.4. Connect the accelerator pedal to the accelerator pedal support bracket half way.5. Connect the accelerator link rod return spring to the accelerator pedal.6. Connect the accelerator pedal to accelerator pedal support bracket completely.7. Install the retainer to accelerator pedal.8. Ensure that the retainers is securely installed on the accelerator pedal.iuqoywr et rywrretqLHDRHDJBO00248-00214JBO00249-00000q Accelerator cablew Accelerator pedale Accelerator pedal support bracketr Busht Accelerator link rod return springy Cushionu Clampi Clampo Clamp
